View Single Post
Old May 1st, 2004, 11:23 AM   #4
Terry Woods
Member
United States

Terry Woods is offline
 
Join Date: Apr 2002
Posts: 3,170
Are both sensors at the same horizontal position? That is, is the upper sensor physically located directly above the lower sensor?

It sounds like you simply need to indicate to the first hammer whether or not to "kick" the part into the bin. If not, then let the part pass the first hammer. Then, at the second hammer, if a part is seen at all, then it must belong in this bin because it doesn't belong in the first bin.

Surely there is more to this than you have said.

(040)
  Reply With Quote