Electricfred13
Member
Hello folks,
I am working on an HMI application in EasyBuilder Pro using the software with the Simulation mode as an MQTT Edge Gateway.
This simulation is communicating to a PLC which is then sending data over to the Scada software Ignition. I have successfully been able to Publish data points through the simulation to Ignition through the HMI but can not seem to write back to EasyBuilder Pro. Any thoughts?
So essentially a subscribing issue.
Thank you!
I am working on an HMI application in EasyBuilder Pro using the software with the Simulation mode as an MQTT Edge Gateway.
This simulation is communicating to a PLC which is then sending data over to the Scada software Ignition. I have successfully been able to Publish data points through the simulation to Ignition through the HMI but can not seem to write back to EasyBuilder Pro. Any thoughts?
So essentially a subscribing issue.
Thank you!