allscott
Member
- Join Date
- Jul 2004
- Posts
- 1,332
I have a siemens DC-AC masterdrive part #6se7016-1ta51-z that is coming up with an alarm A 129 at random, it will run for hours and then throw up this fault.
According to the book that means,
Machine data 1 (position encoder type/axis
type) is 0 (axis does not exist).
Effect:
Operation of the axis is inhibited and the
position controller is deactivated.
And the resolution to the problem is,
You must assign a valid value to machine data
1 in order to operate the axis.
This is on a machine that has been running for at least 10 years. So my question is is that fault triggered because the drive can't see the motor or encoder, or there is something wrong with the paramaterization, or?
Thanks in advance for the help.
According to the book that means,
Machine data 1 (position encoder type/axis
type) is 0 (axis does not exist).
Effect:
Operation of the axis is inhibited and the
position controller is deactivated.
And the resolution to the problem is,
You must assign a valid value to machine data
1 in order to operate the axis.
This is on a machine that has been running for at least 10 years. So my question is is that fault triggered because the drive can't see the motor or encoder, or there is something wrong with the paramaterization, or?
Thanks in advance for the help.