Encoder Programming in Step 7 Questions

arocon

Member
Join Date
Oct 2006
Location
Dubai
Posts
171
Could anyone tell me in the attached program how the MM_Per_Rev value is L#334. I attached the Program, GSD files.

Minimum Position is 0mm
Maximum Position is 5000mm
But the encoder move from 999mm to 3493mm.

Also if any body please explain me what is MM_Per_Rev_Scalar and Final_Scalar

Thank you for your help
 
My first guess is that you need to "zero" the setup. I think the "reset" at your FC561 is for that purpose. I would expect some input from some switch or HMI there and not an "always off".
 

Similar Topics

Some of ELAU SM servo motors utilize SICK STEGMANN encoders of type SRM50. My SM motor had a defective SRM50 and I bought a new one from SICK. I...
Replies
4
Views
2,119
  • Poll
Micrologix1100 PLC with rslogix software. Does anyone know how to use a single turn absolute rotary encoder as if it were a multiturn encoder...
Replies
2
Views
1,396
Might anyone have a pinout of a SICK programmer (PGT-10-S) for use with an M23 adapter?
Replies
3
Views
2,103
Doing my first program with an encoder ever. SLC 5/03 processor with a 1746-HSCE card. I have a dual channel single-ended 30ppr encoder I'm...
Replies
2
Views
2,047
Good Morning, I am building a machine , and I have a side plate with pneumatic cylinders that have a incremental encoder on it. This side...
Replies
5
Views
1,744
Back
Top Bottom