View Single Post
Old October 21st, 2008, 05:39 PM   #12
United States

Archie is offline
Join Date: May 2002
Location: Orangeburg, SC
Posts: 1,820
Nathan... Most of the graphics are based on PNG files because dynamically creating something with that much detail would just be too slow and in some cases just not feasible. The code does a lot of optimization for graphic speed.

Can this work with a GE fanuc 90 micro?
Not currently, but it only requires a driver. It can use an existing driver as I have done with the TwinCAT driver with a wrapper implementing the interface. Does GE supply a free communication driver for their PLCs?
  Reply With Quote