Opening a .RSS file without RSLogix

BlackSky

Member
B
Join Date
Dec 2014
Location
USA
Posts
4
Hello,
I just need to open a .RSS file on my PC, but I do not have RSLogix installed. Suggestions? Thanks in advance!
:oops::oops:
 
Last edited:
RSLogix 500 is required to open a *.RSS file that contains an SLC-500 or MicroLogix controller program.

A very common courtesy service here on the Forum is that if you ZIP and post the file here, somebody will unzip, open, print, and post the results in PDF format.

If you can't post it publicly, I'll even bet someone can do it for you directly.
 
Ron, THANK YOU VERY MUCH!
And you are more than welcome if you need my support in the future.
God bless you!
:)
 
Greetings!

Can anyone please convert the attached files to pdf? I am trying to learn how to program a stepper motor for a project.. and this would help me alot..

Thank you in advance!
 

Similar Topics

N
Opening .RSS file without RSLOGIX
Hello gents, I have two .RSS files but don't have RSLOGIX software to open the files and check the ladder diagram. Can someone open these two...
Replies
2
Views
1,217
[email protected]
N
C
Opening a .RSS File without the program
Hello, I have a .RSS file that I need to view but I cannot find any software that will allow me to do so. I was wondering if any would...
Replies
8
Views
8,108
bce123
B
S
RSLogix Emulate 500 v 6.00 not opening RSS
Hi, I am now working with RSLogix Emulate 500 v. 6.00.00.07 (CPR9) under Windows XP SP3. I have RSLinx Classic Lite Rev. 2.57.00.14 CPR 9 SR 3...
Replies
6
Views
20,765
roxusa
R
Cotafam
Issue with port 44181 Opening
Very similar issue as the last post I had here with communicating our Linux Gateway to an AB CompactLogix controller. I have assigned a gateway...
Replies
7
Views
161
Cotafam
Cotafam
A
opening Cimplicity programs in PAC ME 10.2
Hi All, I am trying to program some new Versamax micro PLCs through PAC using some programs saved in our archive however whenever i go to import...
Replies
2
Views
117
Steve Bailey
Steve Bailey
Back
Top Bottom