ladder logic sequence - PLCS.net

jimcav · January 26th, 2007, 11:17 AM

Hey Guys

I am using a allen bradley 1500 connected to emerson servo drives, before i sit down and reinvent the wheel does any one have an example of what the did to sequence moves. The thing that drives me nuts is there end of index bit always stays on after the index is done and wont go off till i start that index again.

thanks
jim cav

dalem · January 26th, 2007, 02:10 PM

I don't have any examples, but the following may save you from going completely nuts.

Use an ONS or OSR in the rung of your program, so that the PLC only sees (or uses) that end of index signal once. The program will then ignore it until after the next index start. (True to false then true again.)

January 26th, 2007, 11:17 AM	#1
jimcav Member Join Date: Dec 2004 Location: new jersey Posts: 178	ladder logic sequence Hey Guys I am using a allen bradley 1500 connected to emerson servo drives, before i sit down and reinvent the wheel does any one have an example of what the did to sequence moves. The thing that drives me nuts is there end of index bit always stays on after the index is done and wont go off till i start that index again. thanks jim cav

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Topics
Thread	Thread Starter	Forum	Replies	Last Post
CarWash Ladder Logic	sicminds	LIVE PLC Questions And Answers	30	November 14th, 2007 02:54 AM
Slow Release Relay in Telepace Ladder Logic	BillRobinson	LIVE PLC Questions And Answers	3	October 25th, 2006 03:28 PM
Viewing STEP5 in Ladder logic: Software	edward4444	LIVE PLC Questions And Answers	6	May 19th, 2006 06:57 AM
PLC Ladder Logic	sweety616	LIVE PLC Questions And Answers	10	September 3rd, 2005 07:11 AM
Need help with ladder logic problem	RickGilbert	LIVE PLC Questions And Answers	10	June 5th, 2005 02:38 PM



This board is for PLC Related Q&A ONLY. Please DON'T use it for advertising, etc.
*Try our online PLC Simulator- FREE. Click here now to try it.* ---------->>>>>Get FREE PLC Programming Tips

January 26th, 2007, 02:10 PM	#2
dalem Member Join Date: Sep 2005 Location: NE Wisconsin Posts: 101	I don't have any examples, but the following may save you from going completely nuts. Use an ONS or OSR in the rung of your program, so that the PLC only sees (or uses) that end of index signal once. The program will then ignore it until after the next index start. (True to false then true again.)

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)