Machine Fault Simulator, I need your opinion

TimWilborne

Lifetime Supporting Member
TimWilborne
Join Date
Oct 2005
Location
Roanoke, VA
Posts
2,210
Hi everyone. I'm working on a new simulator to help teach troubleshooting skills. The goal would be to simulate an operational machine and then "break it" with the use of 10 toggle switches.

When you have time can you review the functionality in the following video?
https://www.youtube.com/watch?v=RLMvSjoBbSc

Then give me your opinion on
1. What's good about it?
2. What's bad about it?
3. What's missing?
4. What do you think would be some good real world scenarios to simulate?

Thanks for your time
TW

imagea0.png
 
Last edited:

Similar Topics

M
Proficy Machine Edtion Fault Table-GE Series 9030
I've recently noticed that when I open up my fault table I get a reoccurring fault in the controller. Not sure what it is or means, hoping...
Replies
3
Views
2,854
NetNathan
N
R
Modbus I/O Fault Cimplicity Machine Edition 90-30 PLC
Hi, I'm encountering a fault on a remote I/O node that is communicating with a Genius Bus Controller. The site can not risk stopping the...
Replies
4
Views
1,620
russg
R
R
Proficy Machine Edition Fault Table?
Hi, i'm looking for a list of faults / fault codes that appear on the fault table. Can anyone please point me in the right direction? Thanks
Replies
4
Views
6,385
russg
R
jtashaffer
Restarting the machine after a fault
I have a compact processor. The program is for a stacking operation. It stacks many different configuration. The problem is when the operator use...
Replies
5
Views
1,872
T Gibbs
T
P
How to connect to Schneider M241 PLC remotely from EcoStruxure Machine Expert software using SSH tunnelling?
Hello, As part of our project, we are using an M241 controller. This controller interfaces with an industrial computer and a router via a switch...
Replies
2
Views
66
Para
P
Back
Top Bottom