ShamusMcFarland
Member
Hi all. I have been an IT worker for many years. Most of it in server support and networking. However I am VERY new to the PLC environment, but loving every minute of it.
I have a 9300-ENA configured for the NAT piece properly. My issue is with the uplink port. I do not get a connection nor activity light on the uplink port when I connect it to the LAN. I have confirmed the LAN port is patched at the patch panel and the cable is good. Conversely, when I connect my laptop to the uplink port with an IP on the same subnet, connection and activity lights both light up. Why is this happening? What am I missing?
Thanks to all and any who responds to my post.
I have a 9300-ENA configured for the NAT piece properly. My issue is with the uplink port. I do not get a connection nor activity light on the uplink port when I connect it to the LAN. I have confirmed the LAN port is patched at the patch panel and the cable is good. Conversely, when I connect my laptop to the uplink port with an IP on the same subnet, connection and activity lights both light up. Why is this happening? What am I missing?
Thanks to all and any who responds to my post.