RsLogix Emulate 5000 Controler Not listed in RsLogix 5k

I have rslogix 5000 20.01 and rslogix emulate 5000 20.01 installed. The emulator starts up fine and I added it to rslinx but when I go to create a project in rslogix 5000 the emulator isn't listed. I think it needs added into the registry somewhere but I don't know where to add it. I have tried installing and re installing ect with same results. Does anyone know where to add this in the registry? This is windows 7 32bit also

Check out this thread. Sounds like the same problem.

http://www.plctalk.net/qanda/showthread.php?t=83803

You can change the compatibility setting by right-clicking on the shortcut you are using for RSLogix 5000 and selecting "Properties" and then going to the Compatibility tab. If you have multiple shortcuts you use (i.e. one in the Start menu and one on the desktop) you'll have to change both.

I can see the processor in Whos Active but if I try to go to go online ect it says Emulator controlled is not installed but it is. And if I go to new project where you select the type of controller the emulator is not listed.