markguidry
Member
-ifix 3.5
-Roc 364
-mds radios
The System is functioning fine, but my newly added two "compressor running" status will not respond to change.
steps I have taken so far.
*on the roc I installed two iso DI input modules.
* rebooted the roc so the inputs are recognized.
*opcode #1, value 24 & 25= A9 & A10.
* on IFix 3.5, database manager, created two digital alarms ( DA), linked it to VUL# 24 & 25 on the correct roc's opcode.
*EXT...
what are the exact steps in adding a new data point on this system?
-Roc 364
-mds radios
The System is functioning fine, but my newly added two "compressor running" status will not respond to change.
steps I have taken so far.
*on the roc I installed two iso DI input modules.
* rebooted the roc so the inputs are recognized.
*opcode #1, value 24 & 25= A9 & A10.
* on IFix 3.5, database manager, created two digital alarms ( DA), linked it to VUL# 24 & 25 on the correct roc's opcode.
*EXT...
what are the exact steps in adding a new data point on this system?