Analog wiring help

I have done very little analog control and want to see if my understanding is correct on how to wire the device. I plan on using the following devices that I will link to at the bottom: AB 1734-IE4C analog card, AB 931S-B1C6D-DC signal conditioner and an Omega LCHD Load cell. Is this correct? Thank you in advance.

This is my thinking:

Connect 24VDC to the term 10 & 11 on the signal conditioner,

Terminal 1 to pins A&B of the Load Cell

Terminal 2 of the conditioner to pins C&D of the LoadCell

Terminal 4 of the conditioner to pin F of the Load cell

Terminal 5 of the conditioner to pin E of the Load cell

Terminal 7 of the Conditioner to IN0 of the IE4C


http://raise.rockwellautomation.com/raconfig/rtcache/pdf/931s-b1c6d-dc.pdf

https://www.omega.com/Manuals/manualpdf/M4086.pdf

http://literature.rockwellautomation.com/idc/groups/literature/documents/in/1734-in032_-en-p.pdf

Looks good to me..
24vdc + to terminal 10
24vdc - to terminal 11

The rest of the + and - wiring is shown on device wiring and in your post.