Baker in Virginia
Member
Good Morning ,
I am working on a system that will distribute oil to a mixer in pounds , using a Mettler-Toledo scale , to check the loss of weight for the correct
amount. When this 2000 lb tote , gets to a low level , I would like to use air springs to tilt the tote ( Not the scale ) forward to make sure we are getting
the most oil out of the tote.
Do you see any issues with 2 load cells getting the most of the weight ?
It will have a total of 4. The tote stand and air springs will be tared , and will only be looking at the weight of the tote.
Thanks so much for your advice.
I am working on a system that will distribute oil to a mixer in pounds , using a Mettler-Toledo scale , to check the loss of weight for the correct
amount. When this 2000 lb tote , gets to a low level , I would like to use air springs to tilt the tote ( Not the scale ) forward to make sure we are getting
the most oil out of the tote.
Do you see any issues with 2 load cells getting the most of the weight ?
It will have a total of 4. The tote stand and air springs will be tared , and will only be looking at the weight of the tote.
Thanks so much for your advice.