Siemens 611U Tuning for Servo

dripdry

Member
D
Join Date
May 2016
Location
Ohio
Posts
23
Hey all. I'm stuck trying to tune a 611U, can't find anything in Scout for the life of me. Is there some automatic parameter setup area I'm missing? Some trick to it?

The servo is running but pretty badly (it's new).
 

Similar Topics

S
Siemens 611u drive fault A508 encoder fault
We havea 100kw AC motor with HEIDENHAIN encoders ERM 280speed encoder. The motor works ok up to 500 rpm under closed loop control. Anything...
Replies
1
Views
3,714
sammmy_s
S
R
Siemens S314
I have established an online connection to a machine using an S314 processor. I am using an mpi connector and simatic manager. The online...
Replies
3
Views
62
JesperMP
JesperMP
J
Siemens migration error
Hi everyone, i have a Siemens S7-300 Cpu 314C-2 DP with several cards of i/o and servos my laptop has TIA version 16 and 17 loaded and...
Replies
4
Views
132
parky
P
K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
6
Views
214
KalvMavin
K
Rsflipflop256
Setting up a modbus network on a DL262 Directlogic PLC with Siemens LMV 3 Burner controllers as slaves, eight of them, with OCI 412.10 Interface
Good morning fellow sea captains and wizards, I am being asked to do the above and obtain 4 values from each slave, I know about the MRX and MWX...
2
Replies
27
Views
562
Rsflipflop256
Rsflipflop256
Back
Top Bottom