silveera
Member
Hi, I'm Vinicius
I've just started working with TwinCAT and Beckhoff PLCs.
My question is about connecting the PLC to the software. This morning I could ping the PLC from my computer and also connect both TwinCAT and the PLC via Ethercat.
At some point of testing the program, the status of the system went to TimeOut and now I can't connect to the PLC anymore, actually I can't even ping the PLC anymore.
Any suggestions? Thank you very much
I've just started working with TwinCAT and Beckhoff PLCs.
My question is about connecting the PLC to the software. This morning I could ping the PLC from my computer and also connect both TwinCAT and the PLC via Ethercat.
At some point of testing the program, the status of the system went to TimeOut and now I can't connect to the PLC anymore, actually I can't even ping the PLC anymore.
Any suggestions? Thank you very much