Good evening to everyone.
I have a question concerning a soldering system on which I am currently working on RsLogix500.
My output current transformer is 5v / 160.
I have 2 analog inputs, current and voltage, both configured in 4-20mA.
My question is about minimum and maximum scaling on SCP command. Is it correct to enter 0-5v and 0-160 or for volt I should find another scaling?
Regarding the scaling, I see from Rockewell manuals that Input Min and Input Max are 6241-31206. Now I find that the value of the current I read at the entrance is 6200, what do I do? Lower the Min input of the scaling?
I hope I have been clear enough.
Thank you.
I have a question concerning a soldering system on which I am currently working on RsLogix500.
My output current transformer is 5v / 160.
I have 2 analog inputs, current and voltage, both configured in 4-20mA.
My question is about minimum and maximum scaling on SCP command. Is it correct to enter 0-5v and 0-160 or for volt I should find another scaling?
Regarding the scaling, I see from Rockewell manuals that Input Min and Input Max are 6241-31206. Now I find that the value of the current I read at the entrance is 6200, what do I do? Lower the Min input of the scaling?
I hope I have been clear enough.
Thank you.
