MartB
Lifetime Supporting Member
Ok, Firstly I want to state that this is NOT a rant, opportunity to flame me, or designed to re initiate an age old arguement, this is purely my opinion and question.
I am noticing that Siemens questions are being posted more often that either basic PLC questions of AB specific questions.
My question is twofold:
a) is this because of an increase in popularity of Siemens?
b) is this an indication of the level of support from Siemens?
I use AB software/hardware almost exclusively and haven't even seen a Siemens program in over 15 years (apart from those posted here of course), and this is the primary reason for asking this question (if Siemens is on the increase then maybe I need to pay more attention).
Or am I just way off base? It was just a thought that I had reading through threads recently.
I am noticing that Siemens questions are being posted more often that either basic PLC questions of AB specific questions.
My question is twofold:
a) is this because of an increase in popularity of Siemens?
b) is this an indication of the level of support from Siemens?
I use AB software/hardware almost exclusively and haven't even seen a Siemens program in over 15 years (apart from those posted here of course), and this is the primary reason for asking this question (if Siemens is on the increase then maybe I need to pay more attention).
Or am I just way off base? It was just a thought that I had reading through threads recently.