use high spedd counter PLC FX1S

ngoclan

Member
N
Join Date
Sep 2013
Location
vung tau
Posts
153
Hi there!
I'm using mitsubishi plc for some project controling. I try to use high speed counter C242 to reading an speed machine. I use two function move(DMOV) and HSCS(interupt set bit) relate to value of C242 but It can't work even the counter always was got value 0, and can't reset high speed counter C242
What happen with my FX1S plc:

Capture.PNG
 
Last edited:

Similar Topics

C
High speed input
Do i have to use interrupt subroutine, or immediate read high speed input, for Unitronics Samba plc or reading only the correponding register in...
Replies
2
Views
121
chapostolou
C
T
600 Volt High Flex Ethernet Patch Cables
Can anyone recommend a flexible 600-volt shielded ethernet patch cable? I have used them from Allen Bradley / Panduit before and they are too...
Replies
0
Views
98
Tim Ganz
T
A
MOMENTUM HIGH SPEED COUNTER WIRING AND SOFTWARE CONFIG
Hello Folks, Has anyone configured a Momentum high speed counter on Unity 13.1. We need the wiring diagram for Momentum High speed counter and...
Replies
0
Views
72
autodepart
A
K
FTView SE conversion from RSView - High and Low EU properties
Hello, I have converted RSView 32 to FTView SE 14 (I have tested FTView 12 before as well and there were some difficulties so I moved on to...
Replies
4
Views
229
kuchja
K
P
High speed 150V DC Switching source to control piezoelectric motor
Does anyone have any experience with working on piezoelectric motor control? I want to use off the shelf components to hopefully change the...
Replies
5
Views
730
GaryS
G
Back
Top Bottom