Omron CP1E and Modbus RS485

I get what your trying to say now. Ok I guess some reading is ahead, so I can figure out how to read and move the address properly.

Ill keep everyone informed of where I go.


Thanks for the help so far
 
Something else to be careful of, is that 1 16 bit word from the slave may be spread over 2 words.
High byte of lower word, low byte of higher word.

Or, you may of worked that out already��
 

Similar Topics

Hello! I have tried to communicate with a Danfoss drive Aqua FC301 over RS485 but I had no sucess! Attached you will find the demo project that...
Replies
7
Views
4,261
Hello. I have a problem with omron sysmac cp1e controller delayed start. The controller has been working on the punch press since 2016. Recently...
Replies
1
Views
749
Hi, I need to communicate omron CP1E PLC with SCADA to get the status of the machine. There is no etherent port available but an empty expansion...
Replies
2
Views
1,567
Hello... I remove one CP1E from old useless machine and I would like to use it with something else....but it is locked/have no pass/....How can I...
Replies
0
Views
1,417
hi all i have used a real time clock to turn on a bit after 1 month. the plc was off for this whole month and when i turned on the plc after a...
Replies
2
Views
1,410
Back
Top Bottom