Hi all,
I have an issue with programming MATC instruction in studio5000 V28.
What I really need is a way to stop the cam profile when Axis stops and when its resume, the Axis should move from where its stop in the cam profile.
Right now when I pause the instruction, everything pause, but when rerun it again the cam profile run from 0.
is there any way to do that? any suggestion/documents would be really helpful.
I appreciate your response in advance.
I have an issue with programming MATC instruction in studio5000 V28.
What I really need is a way to stop the cam profile when Axis stops and when its resume, the Axis should move from where its stop in the cam profile.
Right now when I pause the instruction, everything pause, but when rerun it again the cam profile run from 0.
is there any way to do that? any suggestion/documents would be really helpful.
I appreciate your response in advance.