grossgrabenstein
Member
Have a Panelview Plus 7 HMI, tested extensively in simulation/on PC, but now using the actual hardware getting popups on the HMI 'The parameter is incorrect.', and the HMI freezes until power cycled.
I need to collect more info from site on when it happens, on any particular screen etc. - I'm just going off feedback from operators.
But can anyone shed any light on what would trigger this popup?
HMI part number: 2711PT10C22D8S
PLC: 5069L320ER
Thank you
I need to collect more info from site on when it happens, on any particular screen etc. - I'm just going off feedback from operators.
But can anyone shed any light on what would trigger this popup?
HMI part number: 2711PT10C22D8S
PLC: 5069L320ER
Thank you