ricoghardforth
Member
I'm opening a exsisting project done in Syswin for a C200HX in Cx programmer. There are two lines which give errors if I try to complie the project in cx programmer which are fine if I do the same in syswin. The two lines are at the end of two sections of code which perform recipe functions and is a IEMS instuction which is to do with indirect addressing.
Its my first time with omron and not sure what cx programmers problem is. I've attached two pics one showing one of the networks with the problem and also the same instuction used at the begining of the section which the comiler is fine with.
Thanks for the help.
Its my first time with omron and not sure what cx programmers problem is. I've attached two pics one showing one of the networks with the problem and also the same instuction used at the begining of the section which the comiler is fine with.
Thanks for the help.