Micro850 Program Loss

Hi Mike and welcome to PLCTalk

How is your ground? other than a grounding issue I can think of anything that would cause it... You maybe able to use a 2080-SDMEMRTC-SC and load the program to that or install a UPS and keep it powered up but I think if I had to go that far I would just replace the processor
 

Similar Topics

C
Micrologix1000 to Micro850 program conversion
Hello, i made a program in rslogix500 for my micrologix1000 plc. can i import this program into the CCW software then convert the program which...
Replies
1
Views
1,469
damica1
D
W
It is possible to migrate a program from Micrologix 1400 to Micro850?
I have an application developed in Rslogix500 for a Micrologix 1400 but for some reasons i now need to use a Micro850 but i dont want to spend to...
Replies
2
Views
2,871
williamp85
W
Z
Micro850 program to RsxLogix500 issue
I been currently working on micro850 plcs and now have a client requesting a micrologix1000. I have converted most of the program to rslogix but...
Replies
4
Views
1,404
ztecarm
Z
V
Micro850 + Sensor: 1 Axis can not move in negative direction when working together with sensor
Hi everyone, I am working with micro850, a proximity sensor (FOTEK, PL-05P) and a 3DOF serial arm robot. I use MC_MoveRelative to control the...
Replies
1
Views
47
vhs
V
T
Micro850, Stepper Drives, and you
HI everyone! I am trying to use a Micro850 to control a SureStep (Leadshine) Stepper drive (DM805-AI) from Automationdirect. I have no trouble...
Replies
7
Views
169
bkottaras
B
Back
Top Bottom