Rslogix 5000

Control72

Member
Join Date
Jun 2006
Location
Hassi
Posts
1
Hi all

Now i am commissioning ABB DCS system and thier are problem in communication with AB RSLOGIX 5000 because the client gave me wrong addresses list for modbus communication.

I could see the RSLOGIX 5000 PRogram and i read some data but i have no experience with RSLOGIX
MCM Port2 Command (0)
MCM3.P2Cmd(0).enable =1
MCM3.P2Cmd(0).IntAddress=0
MCM3.P2Cmd(0).Count=10
MCM3.P2Cmd(0).Device=1
MCM3.P2Cmd(0).Fnc=16
MCM3.P2Cmd(0).DevAddress=1000

MCM Port2 Command (1)

MCM3.P2Cmd(1).enable =1
MCM3.P2Cmd(1).IntAddress=601
MCM3.P2Cmd(1).Count=100
MCM3.P2Cmd(1).Device=1
MCM3.P2Cmd(1).Fnc=3
MCM3.P2Cmd(1).DevAddress=1

Can any one have experience help me to detect the actual address from this data.
 

Similar Topics

Hello all, I have a question in regards to RSlogix 5000. I am having issues with the program force closing when I try to make online edits. We...
Replies
0
Views
95
Greetings ... someone sent me a request for some student handsouts that I developed ... turns out that I had this hosted on my business website...
Replies
0
Views
109
Thank you for any and all responses/help. I have an RSLogix 5000 v20 and a Cognex In-Sight v5.9 spreadsheet (8502P). I can not figure out how to...
Replies
0
Views
101
Hi All, I've been pulling my hair out trying to fix this for a few days and need some advice. I have V19.01, v20.05, V21, V24, V30, V31, V32...
Replies
5
Views
348
Hello Friends I have a installation with v16, v17, v18, v19, v20. When I tried to open a v20 file, the enable source protection was not enabled...
Replies
1
Views
214
Back
Top Bottom