wyrsek
Member
Not really a PLC problem, but was hoping that maybe someone here might have some insight into this issue.
We have several panelviews setup around the building, but one of them refuses to save the network credentials. It is using a newer firmware compared to the other ones, but aside from that, everything is setup the same as the others.
Even within the terminal settings, where ID/Password/Domain go, if I fill in the password field, save, leave the screen and come back - it's blank again.
Every time I cycle power, the login prompt pops up and it's totally blank, like I've never connected to a network before.
If I enter the credentials, it connects and data logs just fine.
It all seems very bizarre.
We have several panelviews setup around the building, but one of them refuses to save the network credentials. It is using a newer firmware compared to the other ones, but aside from that, everything is setup the same as the others.
Even within the terminal settings, where ID/Password/Domain go, if I fill in the password field, save, leave the screen and come back - it's blank again.
Every time I cycle power, the login prompt pops up and it's totally blank, like I've never connected to a network before.
If I enter the credentials, it connects and data logs just fine.
It all seems very bizarre.