AB plc 2/16

Stan122

Member
S
Join Date
Mar 2008
Location
illinois
Posts
1
I am trying to install the ab 6200 software on a flash drive and use a dual boot win xp pc to load win 98 from a flash drive, so far
i have the software working on an old Pc. But i dont have any PLC 2/16 programs files to see if i can open them with the software ( lost all of them when my TI terminal went belly up ). any one out there have a 2/16 file set i can use to try the software?
 

Similar Topics

P
AB PLC, Rslogix 5000, alarm issue
Hi folks, in the alarm manager of Rslogix 5000, the tag-based alarm has been created. But when I tried to change the condition, it was found the...
Replies
0
Views
27
PLCbug123
P
H
PLC NAT Suggestions.
I know this topic has been brought up a few times, but i had some specific questions. I have installed several 1783-NATR devices and they have...
Replies
0
Views
50
HoldenC
H
H
No communication with PLC 90-70
Hello We have installed several G.E. Fanuc 90 70 PLC Everything was ok but suddenly we can not communicate anymore with any PLC with the software...
Replies
0
Views
35
Hazatov
H
Voltimus
IDEC PLC to PLC modbus communication
Apologies for not being the best IDEC programmer. I recently was doing some inspections on a site that had 3 FC6A IDEC processors. The issue is...
Replies
0
Views
51
Voltimus
Voltimus
P
PLC MICROLOGIX 1000 AND 1761-NET-ENI
"Hello! Good day! Excuse me, I have a question regarding the 1761-NET-ENI. RSLinx has already detected it but it's not connecting to the PLC...
Replies
4
Views
98
roxusa
R
Back
Top Bottom