noxcuses
Member
I have a G304K2 connected to an Allen-Bradley L16ER Compactlogix processor. When the two are connected everything works as it should for several hours. Then the G3 will stop communicating and drops off the network. I've tried several new cables and have plugged the G3 directly into the PLC port with a short cable with the same results. The connection light on the switch doesn't change, so it has an ethernet hardware connection. The G3 doesn't reply to PINGS when this happens and the COM light flashes once every second.
To fix I cycle power on the G3 and everything goes back to normal for several hours. Any suggestions???
To fix I cycle power on the G3 and everything goes back to normal for several hours. Any suggestions???