Dustin11H3
Member
Hey All,
I have a 1756-L81E. There is a piece of code I only want enabled when I don't have a communication error present from the ethernet connection. Usually this routes through an EN2T card which I know how to get the fault bits from, however, since on the 81E the Ethernet port is built into the processor, I'm unsure as to how I can access such a bit. Any help would be greatly appreciated so I can see in the code when my connection to the rest of my EIP devices is "healthy".
Thanks!
I have a 1756-L81E. There is a piece of code I only want enabled when I don't have a communication error present from the ethernet connection. Usually this routes through an EN2T card which I know how to get the fault bits from, however, since on the 81E the Ethernet port is built into the processor, I'm unsure as to how I can access such a bit. Any help would be greatly appreciated so I can see in the code when my connection to the rest of my EIP devices is "healthy".
Thanks!