Siemens Et200M

Lc1

Member
L
Join Date
Jan 2014
Location
Uk
Posts
59
Hello,
I have a question with regards to the ET200M remote IO base. Are the input and output modules powered from the system backplane or do the modules each require a 24Vdc supply?

thank you
 
Thanks the modules are:
6ES7321-1BL00-0AA0
6ES7322-1BL00-0AA0
I’m struggling to find this in the manual.

Thank you
 

Similar Topics

AutomationTechBrian
Siemens Step 7, Simatic Mgr, Adding a DO16 to an existing ET200M (Profibus)
I'm just trying to figure out the right method of adding a DO card to an existing rack. It's not the *next* open slot, but I have to move the AO...
Replies
5
Views
544
AutomationTechBrian
AutomationTechBrian
L
Siemens PCS 7 and remote IO ET200M
Hi, I have a question about Siemens ET200M series modules. These will be used in a remote IO panel. In this panel will be a dual redundant Siemens...
Replies
2
Views
1,322
Lc1
L
N
Mitsibushi Q series and Siemens ET200M
Hi, I am incorporating a Mitsubishi Q series (Q03UDECPU) and DP Profibus master (QJ71PB92V) to control an ET200M remote IO (32bit Input card = 4...
Replies
0
Views
1,098
Nforbes01
N
J
Siemens ET200M/LINK issue
Good morning all, I am having an issue with a Siemens rack. My communication card is the 153-2BA02-0XB0 [(ET200M /LINK) Profibus DP]. When I...
Replies
1
Views
2,906
JesperMP
JesperMP
J
Profibus DP to Siemens CP-340 in ET200M
Hello, I am trying to communicate to an RS485 device via a CP-340 RS485 card attached to an IM-153-1 communications processor in an ET200M remote...
Replies
5
Views
5,162
judah
J
Back
Top Bottom