CANCF002
Member
Have a machine with a B&R PLC M 264 and the HMI froze when the run button is press. The HMI buts fine. Please advice
B&r plc m264
- Thread starter CANCF002
- Start date
CapinWinky
Member
I haven't ever actually worked with panelware and don't know anything about them, but if the HMI program is stored on some kind of memory card, you should be able to just buy a replacement HMI on ebay and hope that it's a hardware issue and not a corrupt memory card issue.
Since you're talking about a PLC that has been obsolete for multiple decades, you might want to look to look to the future. If the OEM is still in business, they can probably retrofit the machine with a C70 and some X20. If not and you have a drawing set, any B&R integrator should be able to pull it off.
Since you're talking about a PLC that has been obsolete for multiple decades, you might want to look to look to the future. If the OEM is still in business, they can probably retrofit the machine with a C70 and some X20. If not and you have a drawing set, any B&R integrator should be able to pull it off.
Similar Topics
Hi folks, in the alarm manager of Rslogix 5000, the tag-based alarm has been created. But when I tried to change the condition, it was found the...
I know this topic has been brought up a few times, but i had some specific questions.
I have installed several 1783-NATR devices and they have...
Hello
We have installed several G.E. Fanuc 90 70 PLC
Everything was ok but suddenly we can not communicate anymore with any PLC with the software...
Apologies for not being the best IDEC programmer. I recently was doing some inspections on a site that had 3 FC6A IDEC processors. The issue is...
"Hello! Good day! Excuse me, I have a question regarding the 1761-NET-ENI. RSLinx has already detected it but it's not connecting to the PLC...