OkiePC
Lifetime Supporting Member
RSLinx Ethernet to 1761-ENI to 5/04 serial passthru to DH+ Panelview...
I know, I know that is a lot to ask.
The goal is to be able to program a PV1000 in a frozen corner of the plant from the warm cozy office.
So, is it possible to configure my devices to allow Panelbuilder transfer utility to use an RSLinx ethernet driver to get to the 1761-ENI module which connects to the serial port of the 5/04 which has passthru enabled, it then needs to go out to the DH+ port to the PV1000.
I suspect the 1761-ENI is going to be a problem in this scenario, and after exhaustive searching, i didn't find this particular combination of communication devices discussed...
All responses appreciated...
I know, I know that is a lot to ask.
The goal is to be able to program a PV1000 in a frozen corner of the plant from the warm cozy office.
So, is it possible to configure my devices to allow Panelbuilder transfer utility to use an RSLinx ethernet driver to get to the 1761-ENI module which connects to the serial port of the 5/04 which has passthru enabled, it then needs to go out to the DH+ port to the PV1000.
I suspect the 1761-ENI is going to be a problem in this scenario, and after exhaustive searching, i didn't find this particular combination of communication devices discussed...
All responses appreciated...