We have a ZSK-30 extruder (1996) that lost its program in a power down. I've been tasked with getting it back up. The processor was upgraded to a SLC500 in 2000 and we do not have that program. We do have the original 90-30 program. I need a printout of the GE program to convert to a new processor. Can someone help me out?
Need a printout of 90-30 program to convert from
- Thread starter stmoore
- Start date
Steve Bailey
Lifetime Supporting Member + Moderator
Here you go.
James Mcquade
Member
Have you tried to contact the company / individual who did the conversion to see if they can help?
james
james
Similar Topics
I need a printout of an old LogicMaster 6 (series six) program. I do not have an old PC to run the LM6 program to view it. Thanks for any help.
Good evening.
I display the step number of a SFC on a display.
Sometimes, on a trip, it goes quickly through many steps and I need to prove to...
Good morning all.
I'm working on a rehab where they had a standalone InTouch 2014 HMI that they called a SCADA, but it's really basic stuff. The...
We are trying to poll data coming from a PLC for remote monitoring we have the IP address of the PLC and the default port number and the path is...
The idea here is to provide for a brief rapid influx of message codes while preventing sequentially repeating the same message.
i.e. if two...