Hi,
I am not sure if this is the right place to post a question about touch panel PC software development.
I am trying to develop the control software for a motion control system (also designed by us), the software would run on a touch panel PC, additional hardware connected to the PC would interface to the external devices.
Since there wont be any other applications running on the PC, is it OK to run the application in full screen so that operators cannot access other software ??
Should I configure the PC to run my control software by default on startup ??
Please also provide some pointers in the general look and feel of the software as this is my first software development (on touch panel PC) for industrial use.
thanks
a
I am not sure if this is the right place to post a question about touch panel PC software development.
I am trying to develop the control software for a motion control system (also designed by us), the software would run on a touch panel PC, additional hardware connected to the PC would interface to the external devices.
Since there wont be any other applications running on the PC, is it OK to run the application in full screen so that operators cannot access other software ??
Should I configure the PC to run my control software by default on startup ??
Please also provide some pointers in the general look and feel of the software as this is my first software development (on touch panel PC) for industrial use.
thanks
a