gbradley
Lifetime Supporting Member
So a while back I tried out the G304K200 HMI from Red Lion
In order to get it running, I had to buy the Cable CBLUSB4K to program it, and setup the IP address.
It worked great!
I even bought quite a few more G304K200 units, and each time I used the same CBLUSB4K cable for commissioning.
Then I bought a Graphite G07C000,
and it was cool, so when I had to program it, I used the same CBLUSB4K cable in order to commission it.
This week I bought my first G307K200,
and tried to commission it using the same CBLUSB4K cable, but no luck.
Apparently I have to purchase a different cable for the G307K200.
I went ahead and ordered this cable today.
I wish I knew if there was an easier way.
The HMI has a couple of different USB ports. You’d think that one or more of those would be of some use.
In order to get it running, I had to buy the Cable CBLUSB4K to program it, and setup the IP address.
It worked great!
I even bought quite a few more G304K200 units, and each time I used the same CBLUSB4K cable for commissioning.
Then I bought a Graphite G07C000,
and it was cool, so when I had to program it, I used the same CBLUSB4K cable in order to commission it.
This week I bought my first G307K200,
and tried to commission it using the same CBLUSB4K cable, but no luck.
Apparently I have to purchase a different cable for the G307K200.
I went ahead and ordered this cable today.
I wish I knew if there was an easier way.
The HMI has a couple of different USB ports. You’d think that one or more of those would be of some use.