My friend, i need Program tool V4.0 for NT20M

smile

Member
smile
Join Date
Mar 2004
Location
bkk
Posts
36
I have PT NT20M-DN121-V2 Omron but i not have Software for program this PT.
:(
Thanks for all.
Smile
 
Pt Nt20m-dn121-v2

I have PT NT20M-DN121-V2 Omron but i not have Software for program this PT. Somebody help me!!!
Thank very much
 

Similar Topics

R
Lost a good friend and mentor :(
Some of you may have known Reggie Oeltjen, of Automation Dr's. To me we was a friend and mentor. He was one of the people that helped me get a...
Replies
1
Views
2,002
Racer5039
R
M
Project for a Friend
A friend wants me to control a fan for him, such that it runs when the temperature in the room is greater than x, but only if the outside air...
Replies
9
Views
2,135
MasterBlaster
M
U
Total beginner with SCADA trying to help a friend - suggestions on where to start?
Hello With my background in programming and web development a friend came to me for help building a SCADA system, but I'm a newcomer to HMIs...
Replies
3
Views
1,528
Doug_Adam
D
V
Visiting an old friend.
Consider the following code written on an S7 plc. [attachment] There is an inherent error in this little program. Sometimes the program works fine...
Replies
4
Views
2,445
Eric Nelson
Eric Nelson
A
need help
I was wondering if anyone could help i am trying to use a SLC 500 with a 5/05 processor to set up an incremental encoder to a HSCE2 card? The card...
Replies
2
Views
159
adam 1432
A
Back
Top Bottom