Schneider M340 TesysU - Read Amps??
- Thread starter martin1
- Start date
https://media.distributordatasolutions.com/GraniteCity/2017q3/a36f91d0727b396a42ab2a99a6b9176d9a729151.pdf
3.2 Configuring TeSys U on the Modbus Network with Unity Pro (for an M340 PLC)
The above manual and section should help you out.
Regards,
3.2 Configuring TeSys U on the Modbus Network with Unity Pro (for an M340 PLC)
The above manual and section should help you out.
Regards,
Cheers for that.
I am having issues locating the "Ctrl_cmd_mdb_u_addm" DFB within Unity.
It not in my library. I have v12 installed.
Any ideas??
Similar Topics
Hello all,
I am wanting to update the system clock via NTP in the M580/M340.
I'm aware that we are able to connect to a NTP in the controller...
so i have an isssue where if the serial port of an M340 plc disconnect from the screen it would retain the values of the variables being sent...
Hello,
I'm having a hard time understanding how to get a Modicon M340 to pull a Modbus address from an ABB Totalflow via Ethernet. I set up a port...
Hello, this is a message for specialists in Schneider, I am trying to establish communication in modbus tcp between a schneider M340 (P3420302)...
I need to establish communication between Schneider M340 and S7-1500 PLC.
I am using gateway converter for MODBUS TCP TO PROFINET protocol...