Programming Simatic panels with USB PC adapter?

Gromit

Member
Join Date
Jun 2006
Location
-
Posts
119
Hello,

I know that I can program Simatic panels indirectly via the S7 PLC. We get 24V and 5V from the PLC's MPI port and distribute it to the panel.
Can we miss the PLC. Is there solution for programming the panels directly with the USB PC adapter?

Regards
 

Similar Topics

I have a 6ES5 100-8MA01 that came in without the EPROM installed. I followed the procedure to get the program loaded and it goes into RUN mode but...
Replies
6
Views
930
I have a 6ES5 100-8MA01 that came in without the EPROM installed. I followed the procedure to get the program loaded and it goes into RUN mode but...
Replies
0
Views
408
Hi, I'm trying to program in Simatic Manager to control Vacon X series inverter (old TB Woods) & Motortronics VMX soft start...
Replies
0
Views
1,705
Hello everyone! I've just stared with programming on STL and I have problem which I can't understand. I'm writing programs on Step 7 and I'm...
Replies
2
Views
2,166
Hello everyone! I've just stared with programming on STL and I have problem which I can't understand. I have this piece of code:
Replies
1
Views
1,931
Back
Top Bottom