Hi Guys, I want to do PID controlling for a Hydraulic Cylinder. So basicly I have a 10v analog input from the temposonic for position and a 10v Output Signal for the Proportional valve.
In Allen Bradley I can use the PID-instruction which would be perfect but this machine has a Direct Soft 205 with DL260 CPU and the programming works a little different.
I went through it and found no PID-instruction. How do I get started on this?
If some one can just help me get started, I would appreciate it.
I think It would be something like to LOAD the Analog IP, SUB it form a REF and do some more MATH and then Give it to the Analog OUT. That is unless there is a much simpler way to do it.
Many Thanks
In Allen Bradley I can use the PID-instruction which would be perfect but this machine has a Direct Soft 205 with DL260 CPU and the programming works a little different.
I went through it and found no PID-instruction. How do I get started on this?
If some one can just help me get started, I would appreciate it.
I think It would be something like to LOAD the Analog IP, SUB it form a REF and do some more MATH and then Give it to the Analog OUT. That is unless there is a much simpler way to do it.
Many Thanks