Hi all
Please advise if anyone has a work-around for ff problem: Using a Simatic S7 PLC with a 314C-2DP CPU that was just bought and since the S7 version on the PC is V5.2 SP1, the new PLC is not compatible with the old software. V5.4 SP3 is required to run this PLC, but short of spending the money to upgrade the PC software, is there a way to make the PC see the PLC as an earlier version. Hope this makes sense. Any advice/help will be really appreciated.
Regards
Ktn
Please advise if anyone has a work-around for ff problem: Using a Simatic S7 PLC with a 314C-2DP CPU that was just bought and since the S7 version on the PC is V5.2 SP1, the new PLC is not compatible with the old software. V5.4 SP3 is required to run this PLC, but short of spending the money to upgrade the PC software, is there a way to make the PC see the PLC as an earlier version. Hope this makes sense. Any advice/help will be really appreciated.
Regards
Ktn