Hi all.
Still working with a G3 15 Red Lion panel and need to access 2 remote RS485 Modbus units. We have a new mmtcpbconv-vdc from Procon Electronics as in http://www.proconel.com.au/MMTCPBCONV.htm
Ok I can have both these units on the rs485 part, I can set the IP Address in the converter etc and I have 2 different slave id's but how do I tell Crimson 3 I want modbus at IP (since both units will have the same ip as in the converter) but the different slave id's?
Peter
Still working with a G3 15 Red Lion panel and need to access 2 remote RS485 Modbus units. We have a new mmtcpbconv-vdc from Procon Electronics as in http://www.proconel.com.au/MMTCPBCONV.htm
Ok I can have both these units on the rs485 part, I can set the IP Address in the converter etc and I have 2 different slave id's but how do I tell Crimson 3 I want modbus at IP (since both units will have the same ip as in the converter) but the different slave id's?
Peter
