SLC 5/05 not recongnize ( Yellow question mark)

Rob3192

Member
Join Date
Jun 2010
Location
NYC
Posts
8
I configure the SLC 5/05 for Ethernet and it works fine (device = OK) . However, i don't have the PLC icon/symbol (comm setup or RSlinx )... instead it says unrecognized device type ( yellow question mark).
Any ideas on how to fix this ?

Thanks.
 

Similar Topics

I'm trying to read/write to an SLC5 with a ControlLogix L71 V35 plc that fails. The exact same code works on an L82S with V32. Is there a known...
Replies
9
Views
103
I'm ashamed to admit this but I've never had to replace a battery in a SLC. Some how been able to skip that task in all my years. So yesterday...
Replies
8
Views
215
I have a program that I've used 100 times. SQO settings: File N7:0, Mask 0FFFFh, Dest B3:1, Control R6:0, Length 8, Pos 2. Length & Position...
Replies
48
Views
793
Hello PLC friends. I've been going through a saga of diagnosing and fixing an old PLC setup that I inherited. I am learning as I go. Initial...
Replies
14
Views
298
I had a 5/01 CPU give a CPU Fault. It lost the program and I was not able to establish communication with it. I replaced it with a 5/03 we had in...
Replies
3
Views
111
Back
Top Bottom