Hi folks, I've been having a problem enabling my Kinetix 300 over E/IP. 1stime Kinetix/EIP user here. A few questions Im hoping to find aswers too.. Any help is appreciated
Project Components:
Servo Drive ------- Kinetix300 E/IP
PLC ---------------- Micro850
Software ----------- Connected Components Workbench
I've connected to the drive over E/IP; have modified parameters in motionview, checkphasing runs fine; Digital IO>enable... (all from the manual)
...and the drive will not enable. Shunt in not wired; is this required?
So I found one thread and one written document stating that the i/o expansion block IS required in order to use EIP communication?
Link 1 http://cednebtrc.com/ftp_bbernier/K300 Minimum Wiring needs.pdf
Link 2
http://www.plctalk.net/qanda/showthread.php?t=87477
Any Advice on how create the worlds simplest program in CCW in order to write messages in to the Drive using EIP.
Thanks!
Project Components:
Servo Drive ------- Kinetix300 E/IP
PLC ---------------- Micro850
Software ----------- Connected Components Workbench
I've connected to the drive over E/IP; have modified parameters in motionview, checkphasing runs fine; Digital IO>enable... (all from the manual)
...and the drive will not enable. Shunt in not wired; is this required?
So I found one thread and one written document stating that the i/o expansion block IS required in order to use EIP communication?
Link 1 http://cednebtrc.com/ftp_bbernier/K300 Minimum Wiring needs.pdf
Link 2
http://www.plctalk.net/qanda/showthread.php?t=87477
Any Advice on how create the worlds simplest program in CCW in order to write messages in to the Drive using EIP.
Thanks!
Last edited: