Zohaib Shabir
Member
Hi, Can anyone tell the authentication password of Murphy S1501 Mirco-Controller for Configuration?
Murphy S1501 Micro-Controller
- Thread starter Zohaib Shabir
- Start date
http://www.ignition-service.com/Murphy/Compressor_Controls/S1501/Install.pdf
I would contact the original programmer of the equipment or contact the manufacturer.
Regards,
I would contact the original programmer of the equipment or contact the manufacturer.
Regards,
Zohaib Shabir
Member
OP
glcshortt Thanks for your reply. I have already this manual. But they did not mention in this manual about any password. Thanks again.
Similar Topics
FWMURPHY M i l l e n n i u m P r o g r a m m a b l e C o n t r o l l e r
(w w w . f w m u r p h y . c om)
Local and remote communications...
I'm sure a lot of you already know, but in my time, this is the first occasion to come across the term "Murphy Switch". What is this?
When I...
Hi,
We couldn’t find anything specific, so am starting a new thread.
I’m trying to migrate a config from a ML1400 to a micro820 & am experiencing...
I’m running a micro 820 to measure a tank level, then turning on equipment at certain levels. I have an analog input (4-20) that I’m storing and...
