horner XL4 PLC

Hello Everyone,

I am new to Horner PLCs, I am trying to setup analog input and outputs but I am not sure how to assign the %AI and %AO to the terminal blocks, for example if i want to see a 0 to 10 volt signal from a potentiometer how can see the signal in the ladder logic.

what should be the settings like min and maximum and also does it have to be INT or DINT or real, how can i display this analog voltage thro an indicator on the screen setup.

Same is for analog output, where on the terminal block J2 shoul i wire analog in and analog out.

How should I/O configuration for channel 1, 2 ,3 and 4 should be set at ?

thanks for the help in advance.

Kanwar

The model number of my PLC is HE-XC1E6KP

IIRC, the %AI & AO are 0-32000 for full scale. You then can scale these (INT) numbers to Real, DINT, or whatever, with a scale block...

As for the connections, 0V & A1 would be %AI1...

https://hornerautomation.com/wp-content/uploads/2018/10/MAN1144-02-EN-XL4_Model_2_Datasheet.pdf

Please refer to the datasheet that came with the PLC. This will show you the wiring diagram of the connectors that you are looking to program.
Here is a link to your model 6 PLC.
https://hornerautomation.com/wp-content/uploads/2018/10/MAN1148-01-EN-XL4_Model_6_Datasheet.pdf
Here is a reference to all of the manuals and datasheets for the controller:
https://hornerautomation.com/documentation-search/
The following manual will take you though the steps required to set up the analog input.
https://hornerautomation.com/wp-content/uploads/2014/12/MAN0964-02_XL4_User_Manual.pdf
15.7 Analog Input Configuration is the section that you want to read.
https://accautomation.ca/series/horner-xl4-series/

Regards,