Maintenance Demanded?

Benton

Member
Join Date
Oct 2010
Location
Baton Rouge
Posts
34
We have a Bus fault on an IM module ET200. The status shows that maintenance is demanded and that there has been a loss of redundancy due to problem on DP slave and it gives the address.

How do we correct this issue?

We have changed the module and the only places we get the bus fault is between the CPU and the IM. And it is only when going into redundancy.

Please advise! Thanks!
 

Similar Topics

Hi all, Anyone got Preventive Maintenance Checklist for Rockwell PLCs? I found this article, but it does not clearly talk about PLCs, though it...
Replies
6
Views
349
This is a little OT, but I know there are some experts here on the forum with the relevant experience. I have a project that expects a very long...
Replies
6
Views
1,056
This is a little OT, but I know there are some experts here on the forum with the relevant experience. I have a project that expects a very long...
Replies
4
Views
1,101
Good Morning , I imagine all manufactures are having similar problems. The lack of Maintenance Technicians ( Mechanics ) . Could you share...
Replies
22
Views
3,600
I would like to get the right software for A2NCPU mitsubishi PLC
Replies
1
Views
826
Back
Top Bottom