PMCR
Member
I am trying to test a motion control product and .eds file in RSNetworx for EtherNet/IP.
I am using a CompactLogix L23E QB1B processor, firmware 17.01.
I am using RSNetworx for EtherNet/IP 7.00.00 (CPR 7).
My difficulties seem to be that I can't figure out how to get a Scanner in the Chassis of the CompactLogix system, and then edit the Scan List. I am used to doing this in RSNetworx for DeviceNet, and I can't figure out what I am doing wrong in the EIP version.
A screen shot of the chassis config in RXNetworx for EtherNet/IP is included.
Is there any specific 'trick' to being able to edit a Scan List?
I am using a CompactLogix L23E QB1B processor, firmware 17.01.
I am using RSNetworx for EtherNet/IP 7.00.00 (CPR 7).
My difficulties seem to be that I can't figure out how to get a Scanner in the Chassis of the CompactLogix system, and then edit the Scan List. I am used to doing this in RSNetworx for DeviceNet, and I can't figure out what I am doing wrong in the EIP version.
A screen shot of the chassis config in RXNetworx for EtherNet/IP is included.
Is there any specific 'trick' to being able to edit a Scan List?