vino.singh2318
Member
is it possible to operate a rectifier(rs 485 rtu communication) only by hmi without using plc.
i'm using DOP-B07S415 hmi
i'm using DOP-B07S415 hmi
Last edited:
modbus rs485
- Thread starter vino.singh2318
- Start date
tragically1969
Member
is it possible to operate a rectifier(rs 485 rtu communication) only by hmi without using plc.
If the HMI can be a Modbus master and the rectifier be a Modbus slave then there isn't any reason why you can't operate it.
What the rectifier (if you are describing it correctly) will allow you to do and how you will get the HMI to do it is another matter.....
Similar Topics
I am trying to figure out some communication specifics for a Modbus RTU network that I will be integrating with and could use some help to make...
I'm getting no response from a device I'm trying to communicate to with a Beckhoff IPC. I'm not sure why it's not working.
Attached are pictures...
HI guys:
I am attaching several diagram from several sources, it seems to be that there is no such a wiring standard for modbus RS485 RTU.
In some...
So I'm working on an old project I did several years ago. It has 12 nodes on a modbus RTU network. I'm going back for an expansion.
I'm going to...
Need a sanity check here. It is possible to have redundant Modbus RTU master, but only one master is actively polling at a time?
The background...