Has anyone ever seen a PLC5 just drop communication(controlnet, dh+, or serial, i tried em all) and kill some outputs and then a few seconds later come back like nothing ever happened? I don't get anyone errors at all when it happens inside the PLC itself.
PLC5 80c w/ 2 remote racks via RIO.
1 panelview plus and 1 panelview standard on ControlNet, though I disconnected both of them and it does w/ just my laptop as well.(The comms loss, symptom of the larger problem I think).
Several VFDs on the system, We were able to get this to happen consistently by jogging one while the carousel it was driving was slightly out of position.
I've never seen this before, little bit lost!
PLC5 80c w/ 2 remote racks via RIO.
1 panelview plus and 1 panelview standard on ControlNet, though I disconnected both of them and it does w/ just my laptop as well.(The comms loss, symptom of the larger problem I think).
Several VFDs on the system, We were able to get this to happen consistently by jogging one while the carousel it was driving was slightly out of position.
I've never seen this before, little bit lost!