Confused on COP instruction in Logix 5000

What ASF has posted is more important for the FLL instruction, because the "byte-count" for the source datawill keep getting reset back to the start of the Source data, then it becomes relevant that the destination size x length is correct.
 

Similar Topics

Which of the following input operations require a conversion to digital form prior to input? a) disk b) analog c) contact closures d) limit...
Replies
12
Views
3,825
Hey all! I recently purchased myself a Panelview Plus off of ebay and i was hoping that i could upgrade the firmware on it to Version 9 or so and...
Replies
7
Views
2,693
Hey guys, Im currently using the above flex IO to turn on two outputs these outputs go to two flashing red beacon lights. Here's the scenario: My...
Replies
4
Views
1,681
I'm event AV Technician (Sound, Projection, and Lighting). Over the last couple of years I've used a Weigl ProCommander PHX to control some event...
Replies
9
Views
2,670
Hello all, first post for me here. Im currently learning PLC programming at my local community college, and while its been great, there are some...
Replies
13
Views
3,180
Back
Top Bottom