Please tell me the options for calibrating the touchscreen of the B & R Power Panel 100 4PP120.1043-31 Rev.K0 without BIOS.
After the damage, the touch screen managed to calibrate.
After replacing the touchscreen with a new serviceable one, it is impossible to "push" the buttons - you need to start above the button, off-screen.
There is no project source.
A faulty touchscreen also fails to do a calibration.
Can I reset the default calibration settings?
Where is the calibration table stored?
Is there a way to immediately call calibration after power on?
I would be very grateful for any ideas!
After the damage, the touch screen managed to calibrate.
After replacing the touchscreen with a new serviceable one, it is impossible to "push" the buttons - you need to start above the button, off-screen.
There is no project source.
A faulty touchscreen also fails to do a calibration.
Can I reset the default calibration settings?
Where is the calibration table stored?
Is there a way to immediately call calibration after power on?
I would be very grateful for any ideas!